Elevator Forum

The KCE control is not locked, you can use the push buttons a bit as on the LCE control.If you need to change in parameter or something else you need ...

If you use the PC, you have the overview and can program the buttons as you want.I always use it

Have you changed KSS F2KMUL board?If not, a lon download will not be necessary.Maybe you need to have a PC on`what do you mean by Phase 2?

Page 269 https://assets.omron.eu/downloads/manual/en/v3/l1000a_users_manual_en.pdf

When does the error occur?Did you check the brakes?Try to change acceleration and deceleration. Increase the acceleration and deceleration times (C1-0...

your mail ?

I have sent you information on how to.Can you use it?

Are you thinking of Bionic 7?Do you have a picture of the control

It works fine with windows 10

Your mail ?

Check that Car Comm (D64), Hoiseway Comm (D65) 24V Car and shaft and D74 is light green on the CPU board.Check the Voltage on the LON.You need to chec...

0125 Is the weight adjusted correctly 50% and 0%?0026 Is there a subcode? If it is the old tarco model it may need to be cleaned

Amd doors? make sure the reference switch is adjusted right on the cabin door. If the COP flashed out of service you should get a fault code.

If you are working on a Kdl drive, 108-2013 the parameter is wrong ore the tarcho is broken.

does it not write a subcode? what kind of drive and motor are you working on?