Elevator Forum

That sounds like an interesting combination, normally v3f16es parameters are in menu 2, if it could be in menu 6 you need a newer drive, what kind of ...

I use one from aliexpress, i connect to the wifi and use a app on my mobilphone, almost like the bluetool.dd8ff8aaa8a6261f3c&afSmartRedirect=y

There are 5 buttons on the main board, press the top one until it starts to beep, then press or hold the bottom floor button.

You can't unlock an lce with hyperterminal, you have to do that with uio or knx

You can find drawings on them, so it is possible to produce them locally.

Put it on rdf and change the so it fits to the motor, if you can't change it, it might be nvram that is broken.

Hi Johnny send me your mail i have something

If you do a new shaft setup, the input from 30 + B30 must match with fcb borad as it counts in the lon download. So if it counts the door zone sensor ...

What software version are you trying?I use hyperterminal when troubleshooting and have been able to get by with it.

Fault 50 is missing start signal.. Missing Start Signal Non-manual 1 (If center position does notappear within 10 secondsafter Run Mode entered.) &...

Scribd have some documentation you can copy the link into vpdfs then you can download it.https://www.scribd.com/document/713561549/EJ-41326606-25-2403...

Here 🙂

0 :disable1 :control according : Factory settingto run or not2 :control accordingto the temperature

Now I don't know what kind of escalator model you're working on, but if it's an Kone it probably has a 501 controller, so I'd look at parameter S.03 i...

I use HyperTerminal, Rs232 cable and set it to Baud 9600 bit 8 it works on lce and not on kce