Elevator Forum

I have some electrical diagrams if that's what you're missing.. hope it helps you

LCE can't see first destination elevator identifier node B side

Your input E4 PBCM activated, check the Unidrive faultlist

Drive Belt Supervision 0 - Drive Belt Supervision Disabled1 - Drive Belt Supervision EnabledTo Enable or Disable Drive Belt Supervision

Try that good luck 🙂

It is not always standard software that they use.Note that there are 2 versions of cpu boards. If you have copied all parameters into the sd card to t...

1 Yes, it is important.2 It depends on the age of the lift, but you can see that from the drawing.What was the error before changing cpu?

Is the new cpu ordered on the correct elevator number?Have you check the PFFT board?Is it Mrl tractions ore hydraulic?

Check Mt 5.C.1 PHASE OUT is correct.Try to but i in assembly mode and back again

The lce cant se the MUL board, check led on the board in the lift. It is probably broken

Old cpu? is menu6 locked ?

Then check the hoistway floorboards, if any of them are whit red led light flashing, you can also move the 120ohm resistance to the first floorboard a...

Fault 0213, not floor noted found... check the communication and resistance.option board shouldn't have anything to do with that error, but you can ju...

Fault 0036 is your main contactor, any subcode on 0026? the last (02... something) could easily be the fault 🙂

Error 108 is the tarco, clean it at check it works, and the try with a new shaft setup