Elevator Forum

Do you have an email address, so I might be able to help you?

Ok but check the other things and maybe use Ivmon to see if the fault is in the drive unit

What was the error before changing the board?How old is the Nvram... Also check all the can connectionsE9 NET NOT WORKING- There is something wrong wi...

sftail = Start failIts normal tachometer fail.. Check that the tachometer scaling jumper is in the correct position on the control board 385:A1

Arca 2 whit omron drive..

What kind of diagnostic machine are you using? arca 1 and arca 2 are not the same connector, if it is not the right connector you can lay the canbus d...

what version of ims?

Modus works to Arca 1 and 2 but not for 3. But you can do most things without the usb plug

Main contactor in drive fails to pick but start permit does change, Main contactor and Start permit input picked and dropped for 3 times

Lce operating system right? If it is with the new EN 81-20 standard and the light curtain fails, it may well do this. If can't close the door, it will...

On the option board you set J9 to front ore Rear, The opt board has 8 input. If you need some dokument just write 🙂

Hi If it is an LCE controller, you must check your 61:u sensor (error 72) you should probably make a new shaft setup, menu 5-2-1 (error 83)

In the hand terminal https://www.youtube.com/watch?v=V3rDvjCxJCA

I have tried something similar, the sensor might become active on the bolt joints.Turn off the shaft light and look at B30 or 30 when you run the insp...