Elevator Forum

Any fault codes 14xx, 15xx, 24xx or 25xx? have you tried a roll call ore shaft setup? LCECPU XH12 pins 3 and 4 is resistance less than 55 ohm?

The led light are green ok? the jumper is in the right position A ore B site?XH12’s pins4,3 55-75 ohmVoltage on the bus need to be 1,56-2,5V1 Lon 5-7-...

You cannot use hyper terminal, you must use their mobile app or PC. But you can read fault codes, change many parameters and troubleshoot without it.

Anyone have any good documentation on a Schindler LX? i need it 🙂

Turn RDF (pos.270) ON. Activate lon download by changing value of menu 5-7 from 0 to 1 or 2 and press Select/Accept button.Menu 5 - 1

What software version do you have, what was in the old card?

I have a little bit pm

The display turns off when not in use on KCE or CpuC.You can access it by pressing the menu and the error can be found under E-1 as in LCE.If you do n...

Yes i know pm me

U just need to adjust the brakesKone LCE kdl16s 126 3088 Motor movement [mm] LWD input (mA) Sequential brake dropping warningSequential brake dropping...

I have pm me

02 54 DS Closed end signal is not ON with in 10 sec of door closing .This fault is thrown when the elevator is in Car top / RDF inpsection mode.I have...

Welcome 🙂