Notifications
Clear all
Topic starter
12/11/2021 2:05 pm
Good morning, im busy with a kone mono space lift. The LOP's are all selecting the incorrect floors. Im not able to access the button teach-in menu. Is there any other way to program the LOP?
13/11/2021 2:43 am
Check that Car Comm (D64), Hoiseway Comm (D65) 24V Car and shaft and D74 is light green on the CPU board.
Check the Voltage on the LON.
You need to check the fcb boards and also check the lon ternimation resistor at lowest floor.
Check the Voltage on the LON.
You need to check the fcb boards and also check the lon ternimation resistor at lowest floor.