Elevator Forum

SD is primary (Smoke Detector) and LSD is auxiliary (Lobby Smoke Detector)

Should be sheet 9 of the field wiring diagram Attachments Image 1-2-24 at 4.07 PM.jpeg (330.14 KB, 47 downloads)

It’s really common for guys to put the leads on backwards when replacing the battery. The negative is a smaller wire so has a red Faston, the positive...

As far as I know there is no way to make the lanterns work for car calls. Best I could do would include adding IOs, relays, and running a wire down. S...

Reload the job and generic software

The door inputs shouldn’t cause an Init shutdown. What are the faults and have you tried a GET command?

Ya, the TDC boards won’t even close from the manual switches with the photo eye in the wrong state. I’ve seen the boards get replaced more than once b...

Power off

DMC is 485 but not standard. You need a 232 to 485 converter and it will not work with any kind of USB serial adapter. It needs a native serial port w...

Pretty sure a bad DZ relay on the HC-CTL will cause that.

I have another version that says to also pull XCT1 and XME1 on the ADON board before step 8 Attachments Image 11-10-23 at 7.30 AM.jpeg (569.01 KB, ...

If you know where it goes, it’ll be on the print. You can right click on the IO, click add or change an IO, type in U2, hit enter. WRT it, reset the C...

You’ll also have to teach the riser. TECF, TECC. If the board is used you’ll want to do a TECCR first to clear the old config in the board. Unless you...

It’s in the group IOs. You have to select the group in the control panel then open the IO map.