Elevator Forum

If any voltage is changing at the controller this must be a TAC22 with discrete hall call? Does the IO change state in IMS?

It’s positive and metered logic. For metered logic a green IO is an IO with voltage present (with a meter). Positive logic is for “active low” inputs....

Is FSH2 high in IMS? That’s the monitor for the phase 1 switch off position. If it’s not try TECCR, TECF, TECR, TECC if still no, make sure you’re tea...

The replacement for the 6300DE39 is the 6300DE42

Replace the 12v battery and drain the capacitor on the GCIO360

You mean it doesn’t have a slow start open? Or the open speed in general is just way too fast? Some of the controllers with those operators had an ope...

Keep in mind that you’ll still have to get the 2 boards from TK. The CAN interface board and the main board because it has firmware in it you can’t ge...

Thanks, I didn’t know there was a limit on PMs. Deleted a bunch.

Thanks, Smartrise got back to me. Here are my notes. I guess sometimes you just have to get the right guy on the phone.To add hall call lockouts up to...

Man, I don’t know… with that discrete selector you’re either getting inputs from it or you’re not. And to happen just sitting there on auto or even on...

You need to hit the down arrow once to see learn travel

211s have a discrete door interface. You can put whatever you want on them.

It’s drive specific, what drive do you have

E5 is input 1 on the RS5 card so 1290 would be 60 1 Attachments Image 9-18-23 at 3.56 PM.jpeg (191.35 KB, 31 downloads)