Elevator Forum

I've seen plenty of the enviromax that cause other problems with hot oil, overshoot floors releveling canceling the calls and not opening the doors. A...

Miconic A you need the job # In my area it's usually written on the controller somewhere

Like el said check screen, how's up acceleration? Does it only happen at certain floor?Does it shutdown 1st thing after weekend/morning.

Dovers version of hot? Do you mean the Tlink? Whatever app you are trying to use figure out if you have the correct adapters.

You should call the local and ask where they are on the list.Also this site is open to anyone union. Non Union. Building owners, managers etc.

I work for TK (at least until they're something else?) I have UITs that are locked up. Even our local office has a issue ordering job specific UITs. I...

Don't know the 2755 or 2757 but I'd guess it's an overspeed in the terminal slow down top or bottom. Do your faults give an explanation?

Check your door operator dcl

Re 1854 is the elevator not moving from the landing?The fltn will show time for fault as well as position in the Hoistway Last edited by OH boy; 11...

Is your controller showing any errors like stuck car call?Those buttons wear out and can get stuck in a latched position. You could test buttons on fi...

What style GAL operators? Is dcl high(you won't get close, if movfr's the relays/plug in boards go bad

What valve? Did you check to see that your relays are seated properly? You could have burnt contacts on relays

Dlb159 did you check the gaps/prechecks on the load weigher?I had some door mods done and weights afterwards were all over the place

Agree with low oil Adjust up slow down, also what are your leveling speeds?Jack resync will probably be happening when your oil is cold, Try cat oil d...

There's a parameter "no demand door open" which is specifically for automatic car door and manual swing hall doors