Elevator Forum

Asbury, why haven't you reached out to an elevator contractor other than Otis in your area?Otis is going to quote you higher because you are not under...

Have you tried putting jack slime, cat oil directly on the piston?How do the pistons look You? You can also change the park floor.

I have some Smartrise C4 controllers on Schindler equipment with overhead torin machines. Keep in mind that there are alot of parameters/monitoring th...

Are changing d26 on ims? If so it should show a message. Like 420 said to learn ntsd or some other reason

Does that elevator have fine floor learning?5 6 1

No originally getting occasional preflight check fault, drift on beginning of run(ride quality/noisy stop) brake noisy. Torin machines. Load weighing/...

DZ loss shouldn't cause my all saftey inputs and all door locks inputs(except input for affected floor because it already open)to go low? Also when I ...

I tried to add short video unfortunately it didn't work Original software ver 01.02.64a0 new 01.02.64h0

Drive thermistor, is the fan working?

Is this elevator a hydro? And if so is machine room/oil getting cold?If hydro does it have the tape reader selector? Does it have have parking and is ...

Is the elevator moving? If so are you seeing 30,61....etc changing state? If it's not moving look at that, what other faults do you have (before 01)

Look at the fault description, if you have an android phone there's a miprom 21 app that is helpful. I would start with 26 brake contact. Brake could ...

LAmech I didn't try putting cars on csv override but I did load up the group controller with hall calls and the cars didn't respond.John Jay I'll chec...