Elevator Forum

Also dob and dcb?

Have you traced wires from door operator and saftey edge/photo eye? I had a miprom 1, years ago was flaky with the door operation and ended up having ...

Have you tried to/or unsuccessfully tried an auto tune? Don't know about the evos but I had a lot of Tech 32 model my jobs turned over with incorrect ...

I assume it has a ups/battery backup? That could be the cause of your OOS.

Wltr00 did you call smart rise? They should have an option for ac brake. Seems to me that when it was surveyed that should have been included(ac brake...

I installed (beta test site) h2000. The battery lowering didn't last a year/before batteries needed replaced. Check the basics,New batteries will need...

Did you reset acuma, adon board?

Could be mul board, dob, cable I have had bad button or switch cause 1301 fault.If you replace mul board you have to do a 5:7:1

98 is a "break down code" you'll need your elevator company to look at the fault list to determine what caused it

Try Tepco Aurora CO. They might have it.

Also just found another set of prints, looks like 330 is your drive module fan!

Did you come up with a solution? Looks like the fuse comes off L2,L3 and should open contacts with K201 before going into the drive.

Not sure what fuse you are referring to (where is this located)2103 machine room inspection26 xt or xt1(thermistor)