Elevator Forum

Hi Patrcik,Good to see you here. Wish the Elevator museum was still open! It had a lot of history and a lot of your hard work!I would love a copy of y...

You can start with this oldie... Attachments 69F75158-CCFA-4F9B-B04B-17D34D413171.png (566.31 KB, 73 downloads)

Couldn’t agree more with Master and Norcan! Happened to me during a test. Mechanics didn’t realize the T and Z on the rupture valve and just installed...

Start with swapping out the load weighing sensors to see if that works. If t doesn’t, make sure the OAD Board is wired in. Last edited by NY Guy; 1...

Hey John,Here’s the easy way to know...If the phase 2 key switch In the car has a “Hold” position, then the car should recall to the phase 1 key switc...

That’s an old S and S relay coil. Obsoleted about 15 years ago. I might have that coil on one of our spare parts shelf. I will check on Tuesday. If no...

My hat is off to ya JKH for offering your services! Nice to see professional courtesy!

i looked as well. sorry, dont have. havent seen anything with that 50 relay on it.

I have 3 phase ac print and SSAC.Send me your email.

Check your email.

Hi PES,HERE YA GO...Schindler 330a security code featuretry placing the car at the bottom floor . Open the door. Then place the car on in car inspecti...

Agree with Turbo. I have had KEB and GAL on site at the same time about this machine. When you use the Synthetic pre torque on the KEB drive setting( ...

I have had the pleasure of working on both companies controllers. My biggest issue is the lack of troubleshooting access on the TX' s and like Abe sai...

Sorry, been away for a bit. Just PM’d Blaze. I have a 3 stop print

Looks like they are phasing out the AT400 as well. Limited supply left. Probably have to move to the Glide.