Elevator Forum

Have an MPH 2.PM me your email.

Might have an HLL, if someone can let me know how to post a document to these threads. No one seems to answer out here when someone is trying to help.

I might have a print but cannot post a document to any threads or PM, hopefully an admin can assist me. Hang in there.

I have a couple of Rotary prints as well, Let me know if you might need. And how to post a document, i don't see how to insert a doc and copy/paste do...

I have a Single speed AC with slide doors but cant find how to post the document.Let know how to post it and i will send it.Nyguy

Would you be able to send me some info on where/how to purchase this tool. Looks pretty amazing!

Just found my manual and I seem to be missing the same area!

Millar CVT 8600 hand held can be acquired through Bart Elevator in NYC. Works great.

Hi,Overvoltage faults are usually problems with the dynamic braking resistors either being open or not sized properly for the job. Empty car up or ful...

136 SPU thermal switch fault. The SPU temperature is too high.137 There was a one floor run detection but no slowdown when the position changed.Used o...

Here is one controller i was able to dig up with the controller wiring diagram. Hope this helps anyone who can use it. Attachments CIMG1453.JPG (2....

I have seen a Shepard print in my stash. I will check next week All the best!

I might have one, I will check next week when I get back to office.