Elevator Forum

[quote=SpaceLord]Hello. The major tenant who used to occupy 95% of my building when out of business. I am only left with 1 small company on the ground...

Get yourself a dongle to fire up the LCE.

You have oscillators instead of pencils so could be even more likely to be problem with guides (DBG's). Check that there is enough engagement of vanes...

If it was quiet before then it just needs properly adjusted.

Assuming magnets and DBG's are okay try changing pencils 61U,61N and 30. 0074 faults etc are fairly common faults and well documented

Have had a few similar faults which turned out to be caused by faulty brake pods

I have adjusted lots of these brakes and found that if you use the brake box tool correctly you can reduce the noise of these brakes setting to almost...

Send me your e-mail address.

Unplug white nylon Molex going into RIF board for a few seconds then plug it back in to reset.Unplug the phone plug going into RIF and connect to a ha...

Avoid is my advice. Not worth all the hassle you will suffer when things go wrong.

Replace edges if you are sure there is no obstruction or alignment issues

As above. Press button on door board and open and close doors several times on inspection and see if led state changes.If detectors are activating, th...

No mention that you used test weights to set up new drive ?Check both brake pods are working correctly. Last edited by koneisland; 05/02/16 11:55 A...

The PI showing 16 is the clue. You have lost some parameter settings (probably due to some problem with main incoming supply). Only solution is to rei...

Sometimes wonder how customers put up with having their elevators out of service for weeks and months at a time while their contractor tries to figure...