Elevator Forum

I would start by doing a shaft learn run

Faulty CPU or ribbon cable ?

Kone techs connect to KCE via an app on their phones so it may be more trouble than it's worth if you only have a couple of these units as you won't b...

What fault do you have ?

Unless you get locked out of LCE menus etc. you do not need a tool. Even if you are locked out you can access menus by booting up LCE with a dongle.Yo...

I would renew both step chains

0105 is power supply problem and or braking resistor broken and fault 0213 is no floor nodes found (probably linked to power supply problems).

Presume you're aware that you have to press yellow button to activate battery charging. If so change card.

PM your e-mail.

Check for any damaged insulation in shaft at point where lift stops. I have had similar intermittent faults in the past which was due to this

Be aware that a lot of rope lubricants can be mistaken for rouge as they are the same colour and very messy which lasts forever once applied to ropes.

Rouging alone is no justification for immediately removing lift from service.Ask him to justify his findings with proper facts and figures or call in ...

Was great for stopping the carbon contacts squealing when they passed over the floor bars on the old mechanical floor selectors.

Check all N/C contacts on contactors in series with Start Permit

0036 = Main contactor dropped during travel which could be caused by almost anything.0036 is just reporting that a drive fault has occurred.