Notifications
Clear all
Topic starter
07/04/2017 7:50 am
have no door closing or main contactor or start permit signals to the cpu so it wont run even on inspection from the machine room. any ideas
07/04/2017 8:28 am
Need a few more clues. Do you have a safety circuit? will it run if you close the door by hand? what does the controller fault log say? What mode are you in?
07/04/2017 10:38 pm
Check all N/C contacts on contactors in series with Start Permit
07/04/2017 10:55 pm
Faults???