Notifications
Clear all
Topic starter
08/04/2017 10:54 pm
hello !!!
have a Sigma controller with
ACD=4 (maintanance operation)
how to remove from this status ?
09/04/2017 8:14 am
Do not know anything about a Sigma, but could mainananxe operation mean it's on inspection, either machine room or cartop?
Topic starter
09/04/2017 12:46 pm
I did it, unless Inspection input is BAD in COP or Car Top
anyone know how to check inputs status
09/04/2017 10:59 pm
ACD=4 means car is on inspection. if you didn't put car on inspection from controller. then you need to check car top inspection switch. ACD should be 27 for normal operation. if i remember correctly "A11E" should get you into inspection. "FFFF" should get you out.
Topic starter
11/04/2017 8:38 am
Originally Posted By: Daniel718
ACD=4 means car is on inspection. if you didn't put car on inspection from controller. then you need to check car top inspection switch. ACD should be 27 for normal operation. if i remember correctly "A11E" should get you into inspection. "FFFF" should get you out.
thnks