Elevator Forum

Thanks for your time and for replying. The cable you make works very well with the "Fast Tool" software, but it doesn't work with the "Freedom Tool" s...

That’s what I figured, but there’s always someone who finds or knows of an alternative. And while I do have other options for connecting to the DMC, i...

From EW Attachments IMG_1527.jpeg (71.23 KB, 63 downloads)

Call Hytech - Orlando FLhttps://www.hytecrepair.com/Default.aspx?PageID=ContactAndSupportThey have a DMC1 interface to connect any discrete Door Op.

Are you using new software along with the new CLC? If I understood your explanation correctly, the second stop (floor 1) is a short distance from the ...

I can't say for sure, but I've heard on more than one occasion that the connector is a 485 NULL.

look on one of those floor sw. or open traveling cable dl2vaelciysccfg&st=ua2bzdc4&dl=0brv29aes33vwswg&st=zkz3bobh&dl=0 Last edited...

the 1110 is not related with the other 2 fault , type FLTN to check the date and time of each fault and confirm which fault is leaving the elevator ou...

0080 OverTempMCRDescription:Over temperature detected within Motor Control (VF).Comments: The Motor Control PCB has temperature sensors on the heat si...

It is possible that there is a Drive manual, but Schindler is very close, when there are Drive fault they do not send boards to be replaced , they alw...

Extra Info 79:The LVL_ZONE relay does not match the KLU/KLD

x3.1.1.10 to the encoder (gov) Attachments acum.jpg (110.53 KB, 31 downloads)

If you have an old LON cable, simply cut it where it connects to the PCI and connect the 2 cables into the USB LON, or simply use 2 cables and connect...

add a 2nd or 3rd group and add cars on each group, sometimes happen that your car and group is not G1C1 maybe is G3C1 or G2C1 (Group # C #) Last ed...