Elevator Forum

Try resetting the RIF board by pulling the XS1 plug with power on. The think that solved that problem for me before.

Originally Posted by Rolly You have to have to correct socket for the relay you use or there is problems. Ya Rolly seems like common sense right?But...

I think the blue ones are the only that are legal. They have to be force guided to meet code. The orangish ones are 120vac. Not sure on the clear ones...

Wow that would be a trick. I’m sure putting a DSD412 on it could be figured out but the drive is like 80% of a 6010 controller. There must be a write ...

Ya, I second that. The prints will cost you but not near as much as a mod

That’s too bad, they were Dover. If you just want a set for the machine room so they can’t tell you they can’t work on it, post a couple pics of the c...

The crosshead datatag is not accessible to you but it sounds like it’s a Dover Mod of an old Westinghouse. Your elevator maintenance company should be...

Interesting

I did not know that. You mean just the analog DC drive? This isn’t true of all the older model CPUs is it?

Most of the problems I’ve had on those trace back to those crappy little relays on that board. Don’t think I’ve seen those exact symptoms but replacin...

Should be fine. There is a battery backed Ram chip on the CPU. I’ve never lost a floor table from having power off that I can remember. When they go b...

It is great and with the new IMS that doesn’t have to have the exact IP set you can configure DHCP on the router to limit the range of addresses it as...

192.168.0.3 through 192.168.0.15255.255.255.0On older versions of IMS you have to set the address in IMS the same. The newer versions you do not have ...

Ya, position encoder goes into the DSP through optocouplers on the board and is where the current position is stored.