Elevator Forum

If you have the typical optical governor encoder make sure the plastic is clean and sensor depth is correct. Have you tried a DSP?

Dial Tone Modulation Frequency I think. That’s how dial tones represent numbers. The ability to program it that way can be turned off. I can only reme...

It was probably on positive logic and DLB & DLT we’re actually both low.

You have to have the customer call Kone for that. And if DTMF programming isn’t enabled.

We just reprogram the Kone phone

It’s a relevel

Not going to run while on INIT shutdown. First, right click in the I/O map and select 8 bit ports, then again and make sure you’re on metered logic. T...

This N/C 10A contact is my best guess. If that is the problem a car call at the floor would do the same thing. Attachments 4FE52EFF-F671-4E7E-82E4-...

Only when the car is already at the floor or for any hall call? Both directions or certain floors?

The files, names, and sizes are all normal and I doubt there is anything wrong with the software. Have the tape guides been replaced? Make sure there ...

Reset the CPU

Looks like it’s saying you’re on both directional limits at the same time, no?

That’s why I suggested a power supply. To avoid any voltage level differences between the old selenium and new silicon.

Do you know what the output voltage is supposed to be? Maybe you could go with a switching power supply.

And a hell of a lot better!