Elevator Forum

Tac32 IP address fo...
 
Notifications
Clear all

Tac32 IP address for use with Ethernet cable

4 Posts
3 Users
0 Reactions
2,525 Views
 RKtk
(@rktk)
New Member
Joined: 17 years ago
Posts: 1
Topic starter   [#29474]
Does anyone know the static IP address and subnet mask to communicate through IMS using Ethernet cable?



   
Quote
(@indirtwetrust)
Noble Member
Joined: 17 years ago
Posts: 1759
 
192.168.0.3 through 192.168.0.15
255.255.255.0

On older versions of IMS you have to set the address in IMS the same. The newer versions you do not have to set the Address in IMS but you do have to select the Ethernet adapter you’re using in IMS.



   
ReplyQuote
(@rolly)
Honorable Member
Joined: 17 years ago
Posts: 729

   
ReplyQuote
(@indirtwetrust)
Noble Member
Joined: 17 years ago
Posts: 1759
 
It is great and with the new IMS that doesn’t have to have the exact IP set you can configure DHCP on the router to limit the range of addresses it assigns to between .3 and .15. Then you can leave your wireless adapter on DHCP. The TP link travel router is the easiest to set up but any one that you can install open WRT on will work. I found a powerline adapter that both nodes are WiFi routers so even on a high rise you can use wireless in the MR and when you go to the car you just plug the other node into the outlet and you have wireless IMS in the car.



   
ReplyQuote
Share:
Scroll to Top