Elevator Forum

What are those for?

This little Hermit Shell case fits the TL866ii perfectly (tight)https://www.amazon.com/Hermitshell-20000mAh-Portable-Charger-External/dp/B01N2Y8WTJOr ...

I should have something close

It’s an CPU40. It was in the pic, just upside down. Should that Dallas Ram chip work for either CPU?

That’s a good question and I’m not sure. I suspect they are. I wouldn’t spend extra money for the adapters for everything but some come with a couple ...

I do backup chips when I can but never got to this job. The route mechanic did have all the parameters backed up though. I used to use a higher end pr...

Perfect, I will try those. Thanks Rolly.

Ya, won’t hold parameters. We had one older one to get the car running but want to order some. That ST part number is coming up obsolete and non-stock...

There is a hoistway scan but most likely a valve adjustment. P17 is the up slowdown distance. Check setting in book for your car speed. I’d start with...

Okay, lots of caveats with Next -Up on the TAC20. It works just like I suspect you want on a TAC50-04. Waits at the parking floor with doors open unti...

Thyssen calls it Next Up operation. This should work but if you can wait til tomorrow I can try it in a simulator. Group parameters: LER = 1, LBY = pa...

It hardly has nothing to do with the voltage. A discharged battery can fail a load test but pass after getting a full charge.

First off, that battery doesn’t read 13.7 volts. The charging circuit does. Unless it’s a brand new battery and you just unplugged it.You can also tel...

Sorry it’s been quite a while since I programmed one. You enter the ID, hear the voice file, enter the password and hear a beep? I don’t think I had a...