Elevator Forum

Oh ya the ribbon cable part number is 9863295. Makes it a little easier. And that’s 6300HL1 for the UIT.

Those are all good suggestions too. Assuming you do have it narrowed down to the motor making grinding sounds while running from the manual buttons, I...

It is possible the door board is making it sound like that but definitely start with the motor.

That’s because there isn’t really a difference between a laptop and a tablet running Windows 10. The Smartrise software won’t care.

That’s not right, there is software for a BP2 that has CLC Adjustment 20. It’s AN13, I assume you could buy it from Vertical express but only buy it o...

No, then it would do it on a 1-3 run too. 2 to 3 must be a shorter floor.

You aren’t getting up to full speed. Turn out on up start until you can feel the car get to high speed before the slowdown. Or confirm in IMS but pret...

Battery polarity backwards? Common for guys to put the red Faston on positive and the blue on negative but the color is based on the wire size so the ...

Anyone? I’ll settle for a Motion 4000 print.

You also need a generic software file in the update folder if the board has never had one loaded

I have not heard of that issue but if they are regen drives, make sure the verr test point is zeroed out with the potentiometer. If it isn’t a steady ...

Just IMS

If there is a file in the backup folder it is probably adjusted and you are probably okay putting it in the update folder and loading it as described....

Check J16. It should be 18.And you have to do an SPC after replacing the IOD. If J16 has changed to 0 and you did do an SPC after replacing the IOD, y...