Elevator Forum

God point, with bad o-rings it can also turn itself out on its own until you have no up level speed. If you can turn it by hand the o-rings need to be...

Definitely sounds like the screen is clogged. Do anything but tear the screen off! I hope that sounds as ridiculous to all of you as it is but you wou...

Replace 188E

ECI also has an office in LA if that’s closer to you

The problem with that is you have had both up and down valve faults so 1 directional limit switch can’t account for all of your faults. I suspect the ...

It means the valve output was turned on but the feedback input didn’t see the voltage or the feedback input saw a voltage when the valve output was no...

I wonder if you could re-wind it. You would just need the right size magnet wire and a way to estimate how much wire was on it.

It’s more or less normal for the resistors to be hot. If the diode was shorted it would pull down the 5v from the power supply.If you have no light on...

You aren’t going to find a capacitor under a PA6 board but did you replace the encoder with the motor?

For a hall call you can just cut the common wire at the button.

That was all of ThyssenKrupp

I don’t think the part number on the motor is different depending on which encoder originally came with it but maybe there is and it originally came w...

What’s J16 set to?

It fits great in this little Otter BoxUIT Box

I’m sure they didn’t but it wouldn’t hurt to have the UIT on hand for the future. It’s literally just a generic LCD screen with 4 buttons on a board. ...