Elevator Forum

That fault says it doesn’t have a shaft setup. Does the shaft setup complete and reset without faults?

Do you know what IO it’s not happy with? The fault description says if you flip it on then off inspection it should tell you which IO is the problem i...

The local TK troubleshooter might be nice enough to provide the job file to prevent some other car’s job file and LON config from being put in. Actual...

On an IMC-AC this is exactly what happened when the brake IGBT fails in the IMC unit. I checked an IMC-DC print and it looks like the same is used.

They say Left CWT and Right CWT meaning counterweight. My guess would be rail oilers. 2 for main rails and 2 for counterweight rails.

For the floor table, clear the faults, start from the buffer, bump down off the limit afterwards, then save. If there are any faults they need to be a...

I wouldn’t worry about connecting a computer until you have a solid P5. When you’re taking your 24v readings what are you referencing for ground? Use ...

Is the OCSS DOB input high? Is there an auxiliary COP or is it the phase 2 panel door open button?

World sells a box like that.

Those inputs are on the expansion board. If it doesn’t have one maybe it needs one with that software. I suggest getting truly generic software DK13 f...

Have you read the page about CHS in the manual? Says it requires SP software. Input should be XI3 on a DMC-1 or XI2 on a DMC-1A. Do you have an expans...

Is it failing the hoistway scan or do you end up with floor heights in SEL PAR 1,2,3, etc. Have you ran the length of the hoistway on inspection watch...

I think you’re right. Really need a new, unprogrammed button, replace 6, press the button to program it. Otherwise you’ll need the programming key swi...

What if only Con28 is plugged into the IOA board?

Definitely want to check the fields and armatures with a megger. Make sure those fuses are time delay or motor rated. That’s a pretty big discrepancy ...