Elevator Forum

Just found the parameter list for my version UI 4.44 Attachments Screenshot 2024-12-30 at 12.47.13 PM.png (100.17 KB, 15 downloads)

Originally Posted by MX4 1-87 says it’s not used in North America but if you’re going behind somebody it’s worth it to check. Strange problem, at his ...

I’ve never done it on a KONE machine but don’t think I’d hesitate to do it carefully if it couldn’t quite hold 125%. It’s standard procedure for TK GD...

I’ll have to check 7:35, pretty sure 1:87 is 0 and I have tried 1:64=0. It is a CPU40. I wonder if 1:87 does have to be set to 1 or 3 if 7:51 can’t be...

UpdateThis was the power supply harness connector on the Relay Pilot Board.

Sounds like it lost its parameters. Check some F1 parameters to confirm, especially spare inputs and output. You’ll have to default the CPU and re-ent...

Probably wouldn’t be a problem for PI bulbs but if you put them in a button make sure the call cancels every time. The call circuits need a load to re...

That’s what it does when the association IMS installation needs a site key.

Cycle door power or clear faults from the Command pull-down menu in Door Smart Fast.

It didn’t always but I have noticed it does in some newer software.

That converter was an alternative to the “orange cable” to convert from 232 to 485 for the old Dover DMC laptop program. It required a special driver ...

Have you actually heard of this working or are you asking just because it looks like a FAST Tool? That’s a generic enclosure that Dover used for the F...

If you’re sure there’s no secondary fire switch in a fire panel somewhere they should be deleted.