Elevator Forum

I'm pretty sure we have used an adams over lay for the otis selectors and they seem to work fine.

Originally Posted By: VerticalTechNY Still having issues. Car is still running top to bottom and will slow down and level into a floor and then take o...

Originally Posted By: GreenPants you guys have obviously never dug into a otis next-step escalator. GP is that a NCE type? While not that bad to wor...

I don't know this equipment but i'm assuming its a dc drive type? Your wondering if the tacho is giving an incorrect error feedback? One way to test t...

Before the advent of the EU regs being allowed in AUS, we had to wire all lock and safety cct's in double insulated cable with locks in brown, blue an...

IJGN I don't agree with some of the comments here so I would look at it this this way. We are speculating that these problems are a major issue as it'...

I would think the OOT is an out of time relay. I'm not sure why it would time out unless the doors were actually physically held open and just recycle...

Originally Posted By: sbrmilitia I just took over this job 2 weeks ago. This has been wrote up multiple times by the inspector. Too add fuel to the fi...

Originally Posted By: John Dyer Screw pipe .... In order to perform a repair, I would have to bind the car at the top floor and disassemble the pipe f...

Originally Posted By: danzeitz Or they want your personal guarantee that it is fixed. I tell them Midas is the only one I know that guarantee. haha ...

Originally Posted By: sccjr Give the guy a break he's just asking a question. And if he's a licensed smoke guy he can install smokes and all related f...

Originally Posted By: sccjr Thats good troubleshooting right there. Thats why we get paid what we get paid. We are the best of the best. Good job. T...

Originally Posted By: E311 When I was at the big K-I got a call one night, about 2am. I live in the DFW area and the call was in Washington state-they...

Remember to check the bearings as they effect the running of the doors but its a bummer of a job. Also check the tracking of the huge counterweight as...

I would seriously consider bring your motor rewinders in to test the ac machine properly(they can test the motors better than we can with their equipm...