Elevator Forum

Silly
@silly
Estimable Member
Joined: Jan 1, 2010
Topics: 3 / Replies: 212
Reply

A lot of early installs took the slack rope switch into the lower safety string, so it was in with the pit stop switch. Also had another version where...

7 years ago
Reply

I am south of Puyallup, out in Graham. 1:15 to Seattle in the mornings, and about 1:30 home in the afternoon. I don't mind it because I love the area,...

7 years ago
Reply

Go google 10 things that require zero talent.1. Be on time2. Work Ethic3. Effort4. Body Language5. Energy6. Attitude7. Passion8. Being Coachable9. Doi...

7 years ago
Reply

Apprenticeship will take 4-5 years, flat out no way around that. First 6 months you don't take class, so do the math. Seattle is booming, we have more...

7 years ago
Reply

I would even suggest multiple TECCRs. Say 3 TECCRs, then TECF, TECC last. When I run into a problem I do it from the UIT, seems to have a bit better s...

8 years ago
Reply

Try and reload the group I/O through IMS. I once had a job that the config got corrupted on. In my case it was up calls, my U1 and U2 were flat out go...

8 years ago
Reply

Travis, general rule of thumb is one apprentice to one mechanic. Yes, on bigger jobs they will sometimes have a floating helper or two, AKA 8 two man ...

8 years ago
Reply

Oh I hope his does continue...looking forward to getting my next Probie if this is how they all act... local 19 in Seattle is cracking, my 4th year ap...

8 years ago
Reply

Channel A is car side, channel B is hoistway. Host is on the 188e card I believe. Been a super long time, but it was find and bind for nodes, and addi...

8 years ago
Reply

If it's wired correctly it is in the main COP. Have you tried to eliminate the whole main COP and run off only the auxiliary COP yet? i had an issue o...

8 years ago
Reply

I think the return signal is a power, if it is going to ground, the supply in car may be losing volts, so you could lose all sorts of Crap ( door open...

8 years ago
Reply

What version of software (looks like V5R0N or later) and is this a hydro or traction?1529 means jack Crap on a hydro, this fault populates on every po...

8 years ago
Reply

I notice they are belt drive. I had a bad sheave on a belt drive once that was out of balance. Replaced the sheave and it was gone. Try pulling the va...

8 years ago
Reply

IDWT I found the two processors you were talking about, but most of the information I get back about them is that they hold information and boost, not...

8 years ago
Reply

Very strange. I also avoid plugging in at the CWIL card for various other reasons, but will chalk this one up as another. One thing to consider/rememb...

8 years ago
Page 2 / 15
Scroll to Top