Elevator Forum

I agree with Greenpants. Either do as he says or Mod it. Way to much gingerbread and liability for your own design.

Fault Description:The motor contactor failed to Energize (MCD/MCE)MCD is Active, or MCE is Inactive After a RunPossible Causes:A defective MCD inputA ...

IMS only works on T-IV and above. T-III will work only if upgraded software and CPU installed, then it is a TIV. Last edited by Rolly; 08/16/15 07:...

World Tool sells a Level 4 tool. It does all but LON.

32 Bit with a 9 pin connector RS232...

Is the car at floor level when you find it? Had one of these once that slipped traction on a zoning stop because brush did not provide enough slow dow...

JKH may be on to something if the building has a customer tool IMS PC.

Usually after you rename the Net created for the job elmcannic is right on. Have to close program and restart for sure.

Well for one thing it looks like a very poorly designed circuit. It appears to be a full wave bridge rectifier circuit that has poor protection. Incre...

Cannot be a 6FD if its an AC Motor. They were DC. I could not Identify this unit without a tag or a Sales Number. If you can come up with a Sales Numb...

Check the power supply voltage at the EPROMs power pins .. top right and bottom left on a Chip. Set it at 5.2 at that point. It may be 5.6 at supply b...

I thought World Electronics made a MAP Tool for sale.

send me a PM with an Email address. I have some tool for a car top selector with a tape. Only had one job with it. At the time it was a nifty selector...

Be careful with the slate boards. They are full of asbestos if broken or drilled. It is mixed in with the Slate Material. Use the rare ingredient of C...

Send me a PM of the pic or post it here.