Elevator Forum

Rolly
@rolly
Honorable Member
Joined: Jan 1, 2010
Topics: 3 / Replies: 726
Reply

Car door sagging open enough to break close limit?

9 years ago
Reply

Do you have the Reynolds and Reynolds TPVM-400INT-40? If so the dip switches are for timer.

9 years ago
Reply

I have one set of old Armor prints, your welcome to a pdf copy of them if you Private Message me your email address.

9 years ago
Forum
Reply

Check 018 and 019, Open Backlash speed and Backlash(time)

9 years ago
Reply

Does it do it both directions or only one? Usually that is an open NTS/ETS switch at one of the terminals.

9 years ago
Reply

which fault comes first?

9 years ago
Reply

Yes, 1200, 8, N, 1.

9 years ago
Reply

Possible bad modem on CPU card or Group card. If only one car does it in the group I would suspect that car's modem. The com cable plugs directly into...

9 years ago
Reply

Westinghouse door locks bounce. Try putting a .25-.50 second timer in series with door locks at controller to de-bounce. This was a common problem wit...

9 years ago
Reply

LRV-3 & 4 uses tones like a phone for hall call registration. There is a tone tester for these jobs also. The modem is located in the COP.

9 years ago
Reply

Get your QEI if you don't already have it.

9 years ago
Reply

Do you have IMS?

9 years ago
Reply

Surprised there is not an alarm in lobby or someplace making noise to annoy until fixed.

9 years ago
Reply

Sitting on top of the car with a meter on that junk, you may end up stuck there. Make sure you can get hold of someone to rescue you.

9 years ago
Reply

Generator, Robicon or Louie Alice drive?

9 years ago
Forum
Page 24 / 49
Scroll to Top