Elevator Forum

That sure sounds like car being held at zero speed to long. It will keep drive energized until it sees brake switch dropped. If it was the brake micro...

Or a pilot relay.. also make sure the brake switch is working properly. Could be a timer holding car at zero speed when stopping at the floor. Usually...

97 is from the Drive, Excitation contactor stuck closed.

The machine is junk. The traction relation is horrible. Even roped 2:1 they slip like crazy. When something goes wrong you can only get a new machine ...

I have an Invermon 2003. Not sure what the version number is. It should work. Pm me an email address.

I may have the Invermon 6 software, PM me an email will look now,

FATL means a Fatal Error to shut car down.

Top speed should be 6.35v (MP1/A6)Overspeed Volts 6.99V (MP6/A3)Field weakening 5.71V (MP11/A3)ETS MP4/A3 (P4) Not used set at Top speed to prevent st...

Zach, Check your 5 volt and 35 volts on power supply to make sure timers will work. If your Photo eye or safe edge is tripped when the car is supposed...

What that means is Post to Technical Questions and not here where people looking to get into industry post.. DUH!

Your in the wrong area of the forum.. post under correct topic.

Well unless you did a transfer with IMS there are no files to upload. The .dat files are to be uploaded with hyperterminal using the reset and UDL but...

NOOOOOOO Those supervision relays are the 616L1-2 relays. That IS the ETS circuitry. If you raise the voltages up above top speed on P3/P7 on A3 (P1 A...

Be sure you have not over ridden a safety device in the hoistway.

Actually MP11 on the A3 is the overspeed pot. The pot you turned is for one of the hoistway switches. That pot sets the voltage that the 616(X) relay ...