Elevator Forum

There is a redundant circuit in the 616L(x) relays that will do this to you. It is to check for the existence of ETS switches in the hoistway. I belie...

UCA3 monitors the UPS supply

Usually works for everything.2.5 sec for car stop time4-5.0 sec for hall stop time5.0 sec for standing stop time.1-2 sec for reversal time.

Make a new net on IMS and do a new Hoistway scan.

Make sure you have low-movement micros on them too.

I had one that would not run on inspection until I cleared all faults and logs with a svc tool. Worked fine then.

Try Shift + 5

PM me your email will send you a Tech Article. There were two kinds of these operators. 1. Reactor control with the pots on Door control Box with cams...

I sent you a PM with my email

Pm me an email and I will send you my email.

If you have an extended panel, say for fire service, relays get aux relays get named after the last letter. There is a GLX relay that means car is mov...

GLZ stands for GROUP lobby zone.

Check all the pico fuses on DSP and CPU boards.

11 or 23 UCL is the controller type and the numbers 11 or 23 means the size of the generator starting switches. There is no GLZ on a standard 11 or 23...

Elevator Nut: there is no GLZ or zones on a 11-23 UCL duplex. GLZ is only on AU1, AU2, & AUV. Those are group control systems and not a duplex. Yo...