Elevator Forum

PM me an email will send you some different info.

BTW it's Epoch..

Also have a 1-SOB A-7383

Do you have a print? I have a 1FSOB C-6810. PM me an email will scan and send. Does it run from car buttons and not hall? Does anything on controller ...

Power everything down one at a time, and restart with a laptop hooked up. It should so a system confidence test. See if it says all is ok.

You might try Bill Raffa in California. He is an expert witness for court cases. If he is still alive. Will PM you his phone number.

Make sure you have the ADON 2 write up before you start.

Could be, don't even know what country he is in.

Upgrade all lifts software..

It's like getting extra info on a Schindler Fault. Had a T-4 once that I found the car going to inspection for a moment because of bad travel cord wir...

OMG 3.19 is soooo old you could have many problems if that is in the cpu. Need at least 6.7.25 What country are you in?

Check the Parameters. What version of software you have and which CPU, 561 or 40?

Also try clearing all faults (RFL), then run car, when fault happens before moving car enter FLTN and get info.

If you have exhausted about everything, do check the travel cable. You could even try switching those wires to shielded pairs. Think there is spare sh...

Sorry I am in USA. One brake is used for Emergency Brake and does not normally drop until goes to sleep. Other Brake picks and drops with runs. Make s...