Elevator Forum

I used to use the AAA mini mag led. They kept breaking so I bought a streamlight poly tac LED. It's bigger but I've had it for three years now. It's h...

Have you checked the governor encoder vs the motor encoder. They should be within 5 fpm of each other.

is the loadweighing calibrated correctly?

Is it using a tape reader? If so, the guides may be worn to much, giving it to much play.

Could be the door open limit not making. Or door close limit not breaking.

Does it have a down directional limit? Maybe open not allowing it to run down. Not familiar with this system but have had it on Otis and TK systems. B...

B and BE are the LEDs. They have to drop and pick together.

It's most likely the transfer of power that causes it. Last edited by Magic smoke; 07/17/15 03:18 AM.

Draka makes a Jacket that Velcros around the cable. It's mainly to protect against divider beams but maybe an option for you.

Brake switches dropping in flight, LB relay dropping in flight. Drive losing brake input. All can cause this fault.

Yes, I found it disturbing!! I saw it in a post as this guys avatar. All I could think of was why?

Some yahoo - "Hey mister elevator man. Can I press this button."My reply in a serious voice - " only if you want to ride the elevator". It's like a tr...

good question. No oxygen no rust. Added bonus would be water jacket to keep it from overheating.

Sounds like your motion control board(mcss) locked up. Glad you got it going. I might would replace that battery. FYI if it ever starts going on fire ...

Just the door operator board should be a straight swap.