Elevator Forum

Well put......

Seen him last april, don't know if he has any information available. Still a salesman for them. Seems to be alive, LOL. A little stingy with Garaventa...

Ted is now with Access, try giving them a call at (414) 727-6249

Does the AK3 need a Dongle

Still running strong (as they usually do) Not a problem with it since. Thanks for all the suggestions I got from this post and all involved.

Emergency recall just drag the cars to the designated level and parks them there doors open no phase 2, is that correct?

Plug and play, make sure rotary switch is in the corrct position and the plug jumper is removed from the botom of old board and placed on the new.

2 is your hoistway position dto door time protection open, doors failed to open.

Any Voltage on the coil? Residual magnetism?

The card that turned it for the worse was the car card? But the Ghost came back next day. Went over screw terminals in car and controller, Loose groun...

On there newer boards they have elimited them. Had 1 fail, and they said that it could be jumped out. But I would call to get that on record from the ...

Just had it happen, ghost calls, car and hall calls. WTF....Checked PC to 24D 27.2vdc, SC to SP 5.08vdc, PC to 9vd 15.9vdc. Didn't think it to be crac...

Single Bottom Jack. If the original has not been replaced. Be proactive and have it done with the Mod, it will eventually fail and you'll be without t...

If the tach wires are run in the duct you may be picking up noise from un-associated wiring like motor leads. Those should not be run within 3" of eac...

Here is a place to start. www.elevatorsource.com/elevator-consultants.htm