Elevator Forum

I don't think you are going to get a good answer here. That is because elevator people don't like MRL's. If I can't touch it or see it, I, myself don'...

Belt/Chain Tension, Sheave bearing, all good?

Had this problem, watch your inputs on the micro-processor. Reed switches. First, Then all of the above, I spent months on this. Reed switch bad out t...

What type of operator? Just saying, I found bad diodes, 1 shorted, 1 open, on a DC68 mark II. Doors would hang open, even with SE out. Diodes not on p...

I'm pretty sure it's the inverter, pm me an e-mail and I'll send you what I have.

Yes, I do have the manual, and Ha-Ha, I have the bolt.Thanks

Well Dirt, as luck would have it, it's a torin ER6 machine 2:1. Guess it is time to get weight here. Checked all the other stuff already. Luckily for ...

Up level sensor stuck on

Love it, unfortunately it doesn't happen enough. Not too many new mechanics care any more, (just get it done), is the new motto.Wish you luck R925 ...

Had this once, Perform teccr first that erases all prior configurations then do tecc then tecf for front and tecr for rear.

I have two 330a's 5 stop w/ fire service on 5. Oil level sensor in tank check oil level when on top floor. That will cause AST if oil is low. Check oi...

Well, I'm putting this one away. When checking for a ground, found wire out of terminal feeding rem, which was off-line but what the hell, put it back...

Sorry for the delay, QL door operator. Still in the woods.