Elevator Forum

Rolly, yes the cpu power supply was changed. El, thought the same, moved rails in before I changed the Hatch Proximity Switch interrupters, is what SE...

Well RB1 didn't do it, Makes me think more, so do you suppose it could be the tone board. It would be a surmisation, but, if it stays at the floor I c...

This Error is logged if one of the inputs failed the CIO test at the start of a run.

Don't know anything about these, but my guess would be a back contact of the safety check. On inspection it does not do safety checks.

Occurs when software detects that the Stop-Override switch is bypassed by a contact-short (RUEHC1,2.) Check CIOHNA hardware. Extra info: 65 Stop-Overr...

Not to go on a rant, 400A with SDM present for it's entire life. All of a sudden becomes INVALID...... Sure seems suspicious to me. I know that there ...

pm an e-mail

I'm looking for one also....... sure would appreciate it.

24 volt power supply in the drive?

Recommended: all chain. But I'm not the Boss. If you do partial problems could be worse. I've done a lot of chain.

Two sections of bad chain.

Sounds reasonable, pit ladder must extend 48" above the sill and or handgrips must be provided to the same height. The rungs must be 16" wide and the ...

When you get the call, that is when they need you. Remember they can call the next guy and you won't get called again. Simple as that.

Woot Woot, re-load now brought them up. In the vault. HN problem, my bad, upper right corner IOC CON44, don't plug CON38 into it. Just to make it know...