Elevator Forum

Roped hydro,top of hatch,rode the head up,lots can go wrong. Pinch, Crush, Fall. Stupid

It's easy to wrt d26=1 by mistake, just think of someone working on a bank of cars and he wants to take control from a different controller. He then d...

If d26 was 1 and someone wrote it,any power loss will cause it to go back to 1 although it was changed to 0. if it happens again write d26 at 0

I agree with Silly. If you can put your name on it, you will be around a long time.

They are the predecessor to the miprom 1, prior to the SRB version.

Call an elevator company to diagnose your issue. You should not try to work on elevators if you do not have the qualifications to do so.

As far as no hall calls in emergency dispatch are both cars to run? Did both lower?

In IMS Type in DHNF and it will poll the HN's and tell you if they are communicating. Where it says on you will have a 1 if it is online and a 0 if it...

Silly,Good to know it's a Tac22 chart and I was lead to believe it was the same as 20. Got to do some digging. Thanks

Found the part#s

SEES inc. pg 403 DCH-16 30 degree bevel on top,20 degrees on bottom, 3 1/2' shunt.

I see it, it is a COA-29 style. That has a bevel on top and bottom in my book.

DVE-7? OR DVE-70 Voltage/KW Last edited by JustWolf; 04/15/15 05:47 PM.

Did you check the ourput card on the car that recieves the down calls? Maybe a bad output.