Elevator Forum

had a double-decker Hydro four stop that the consultants wrote up for one car leveling faster than the other.

He just posted in the wrong area. Give him a break!!

f the worm is moving 3/8" back and forth, you probably have a thrust problem. You should look soon, could be dangerous. If you are saying that the bra...

Telemecanique can probably help you set up the drive. They are pretty basic. Acc rate, dec rate, coast to stop or ramp to stop, max hz, etc.

Contact Titan Machine in New York. They can tell you backlash setting, but my experience is about .006-.008 Larger backlashes in very cold climates. W...

Are the slots in the vanes clean?? Have the vanes been moved?? Are you testing the NTST/ETST and the unit is failing, or are you trying to setup the N...

Do you have prints??

Tape guides (define position relative to switch activation) New scan of Hoistway?? Switch position, switch rollers,

Do you know what version you need, I think I have some floating around in the sleeves

The 24 volt you need is 24VDC. There is a power supply that has 120vac at one end and 24vdc at the other. If this ssupply is bad, the unit will not st...

Take a picture of the symbols you want information about.. I am sure that we can identify them for you. A picture of the symbol in the circuit is pref...

Pivots & Pivot Hinge Door Hardware Sets - RIXSON › products › pivots-and-pivot-s...

Lots of ways to do this. Hang all three reels on a pipe in the pit. Car at top of hoistway .Remove cables from cwt. Remove cables from comp sheave. Sh...

Sch 80 can't be rolled. It must be grooved or threaded. Vic fittings of the correct type are rated for use with sch. 80 seamless tubing. (pipe)

Is there a low pressure setting for this valve? Is there a maximum number of relevels allowed?