Elevator Forum

I asked you some questions on the other post. The IDEC IZUNI Corp FA-2 is the programmer that I have used in the past. I am not familiar with the Omer...

There were lots of problems with the original board arrangement on those operators. There is a real slick replacement board manufactured by PCI or PMI...

What software version does your elevator have. It should be written on the eeprom. If you put the settings back where they started, do you have the or...

You might be able to remove one at a time and send to world Electronics and have them repair the board. If the first one works like you want, then pul...

Can you take a picture of the fixture? Some DMC's had a digital display, and not just discrete numbers. I would look at Vertical Express catalog for t...

Piggy back exciter is basically just a rotating power supply. It puts out a constant voltage that is used like a rectified power supply. Maintain brus...

Is there something in particular that you want, or want to know.

Did you ever find a print?

C relay is the safety circuit.. Does the coil have voltage across the coil leads. Dashpot fluid for the overloads is available from Allen-Bradley.

2:1 little more complicated, you will need a device to hold cables and you need to do this at the top of the hatch. this one is easier with 3 people, ...

Is this a 1:1 basement or a 2:1 basement?? 1:1 Put car mid-hatch, pick up to shorten ropes and slack cables on machine make a holder for new cable ree...

Will it run up on inspection? After hoistway setup, does it show in service?

IBM or Card job

Rotary with a berry (?) pump

Marc, I dont think Christy is still with us. The entry you are looking at is 4 years old. We may never know if Christy found one or not. Most often th...