Elevator Forum

Wrong common??? Is this a new job, or an older one?? Is there 24vdc between the commons at the hall stations??

I have some eproms and eeproms from years ago. Do you have the ability to read and write the programs into the chip? Do you have any other information...

They are in Tallahassee Florida. Your pictures tell us what company, not what controller or type of elevator...

You might want to check with Titan. They have a lot of info on older machines

Change the parameter that controls the type of FireSercice that you want. On new board, set floor tables correctly to tell the unit it has three floor...

Grounding won't help. The faceplates and boxes should already be grounded. I think the biggest problem with static is low humidity. You might ask the ...

could it be on the direction limit and not being able to see LRD signal?? Is this unit on switch leveling or off switch leveling.??

I believe that slowdown distances are in the valve adjustment portion of the software.

parameters for slowdowns?? Inches in both directions sounds like slowdowns are set too close to the floor. What valve do you have?

How much overshoot?? Slowdown distances in parameters??

Montana, I don't think this guy is in the trade, or if he is, he needs to ask an experienced mechanic to show him how to do some simple tasks. I was k...

You have a Cimarron, I don't think I spelled that correctly. Anyway, the piston is an integral part of the sling. I don't think it can be detached fro...

What do you want to do?? Is safety circuit up? C and cx energized? Are doors closed? How are you trying to run the car from the machine room?? We need...

Put a 100-150 ohm resistor across the p150-g150 wires going to the board, but not attached to the board. If the voltage drops off to 108vdc, look off ...

Welcome to the forum.