Elevator Forum

I believe they will run without the RIF. Have you tried to remove it?

Unfortunately it is a fact of life, to work on any older equipment, no matter who manufactured it, you need to be able to read and understand a straig...

One other thought, a lot of times replacing the selector leveling board would be a place to start.

20 years ago this was our everyday world. You have to play detective and eliminate problem areas from your thinking one by one. A lot of times when a ...

call CE, they have a support line.

beapeep is correct, you have to be on the bottom limit before starting hole count.

On the car that was parked at the top, check that CSV override option is false, it is in the option adjust menu.I f the car has IPD you can lockout ha...

That would be my guess also JKH.

You should have had an unintended movement fault. If you put a full load in the car and the doors are open, and you let the car slide through the Brak...

thanks for the update. It really helps to know the the final outcome.

In MSU Adjust, is jog at 100%. If not correct to 100%.

The M contactor if worn may be hanging up as it tries to pull in. Also make sure the coil is not flaking out intermittently, and there are no loose co...

yes add 1 stick of dynamite, light fuse.

You may have to start swapping boards, MSU,Relay Pilot< and Motion Adapter, are suspects to try.

A couple of Drive Parameters to check are, 621 feed back device, 558 ME base speed, 606 Motor Base speed, and 607 and 608 speed limits.