Elevator Forum

I believe it is for Inspection overspeed. Attachments Screen Shot 2023-05-19 at 5.20.21 PM.png (152.23 KB, 23 downloads)

TK is installing a MAD system too.

Sounds like your edge is wired backwards. N/O vs N/C contacts.

JAMOF is a little switch near the SMLCD

Originally Posted by Vatorfixer Good idea keeping some spare up adjusters they seem to leak and plug often. I also had a spare plate that they screw i...

That’s a no, it won’t thread out. If the filter is clean you can just replace the o-rings but it’s usually no. Best to keep a couple of the up level a...

Which faults exactly? Wire it onto machine room inspection, clear the faults and reset the CPU. If it come up on “inspect” does it run on inspect? If ...

I sent him this print over the weekend. Still waiting for an answer to my question because the only single failure I see that would cause that in both...

It’s ROR on the print not RORO. All the prints do show the option as HTP Hydraulic Telescopic Plunger. It might need the ROR relay with the RORI monit...

They do, called Recycle Operation. I couldn’t find a setup document for it but it can either be based on number of runs or switches. Looks like if you...

The doors don’t stay open until you put a call in do they?

To do it in software, the job will have to have come with Key Security. They came with either BAC Button Access Control (like coded car call) or Key S...

Software tends to be a go/no-go type of thing. I’d be really surprised if the software was causing the thing to intermittently go on fire service.

I don’t think the CADI is going to help with an MPH II… You need an HHT to talk to those.

A DMC-1A is the budget model without a selector so they don’t need hoistway scans. And I don’t think you can manually enter floor heights.