Elevator Forum

And you’re using blue IMS? Tac20s are slow. In the bottom right corner it’ll say no device connected, then direct connection and bounce back and forth...

What connect button? You have to make a network, group, & car in the control panel, then plug in and wait for it to connect with little red plugs,...

You guys nailed it! I’d done a 5-7-1 but apparently it didn’t take. I swapped the board to the other car this morning and it came up with the same fau...

Pretty weird that you’d loose your floor table… You can do an FCP command to see if it’s really gone. Make sure it runs on inspection so you know it’s...

Ya, menu 6 parameters are in.

Anyone seen this before?

The 211 has recently become “obsolete” sounds like the sales dept is just using that to push mod sales. The 211 is a great elevator and I would not re...

You can actually buy the softstart kit from KoneSpares and the harness just plugs in. Not hard to wire it in otherwise though.

Here ya go Attachments 113A043D-DEAE-4E57-B09C-78828CDAFA5E.jpeg (233.71 KB, 268 downloads)

Here are the prints I found Attachments ME-HF-1970-WD-003-002 3S SAPB ML DR (SAN JOSE) CL_Page_1.png (268.15 KB, 26 downloads) ME-HF-1970-WD-023-0...

I have not, you think that serial number off the cross head data tag would work? I did end up finding 3 prints that are similar. They have a K relay f...

Ya, the terminals and relay names are pretty similar to Montgomery but I'm stumped on it... I hope someone out there know what it is. Attachments I...