Elevator Forum

Put DCL as close to full closed as possible without being intermittent or relaxing off of it. Then run a new scan after moving the limits even a littl...

Ya that could do the same thing if the belts slip while the door is squeezing

I always start the scan on a DMC with the doors open. Maybe if the limit was way too early… When the doors close at the floor the count matches the sc...

DMCs don’t have discrete door IOs. As stated above, when a discrete operator was required Dover installed a WCR or an LMH. It’s possible Miami was usi...

If you look at all your fire service inputs, does the CLC see any incorrectly?

As far as I know, the serial adapter board for the LD-16 still doesn’t speak DMC. It does 485 like Tac20, Tac50-04 and CAN.

I had one doing some strange things on fire service. I’d even replaced the CLC by download and upload from FAST. The solution here was to do a cold st...

TAC50-04s have no LON. You can’t really make a harness for the old LON Talk card. You need the LON Talk harness.

You have DMCs with HD-LM operators that have a 6300PA door board in them? I didn’t think that was possible, the PA boards do CAN and RS485 but not DMC...

I’ll send you something else

https://www.dropbox.com/s/sl6fmliqv7kbsfx/LVM2%20Softstart.pdf?dl=0

Back when you just had the Personality fault, did you find any Display 9 or Display A parameters that were not right?

In my experience elevator brakes only get louder as time goes on so don’t expect it to get better. A lot of MRL brakes, the ones that are adjustable a...

If you have the USB adapter I can show you how to make an adapter harness

This looks pretty close. I think 3 diodes should be fine.https://www.dropbox.com/s/krxk7ejxsf9f80n/1969%20PB%20Hydro%20Fleetwood%20GAE%20.pdf?dl=0