Elevator Forum

If you already have 1 Pixel controller I don’t see any reason not to go with that. I don’t have a lot of experience with them but that’s because the o...

It’ll work over CAN. Nothing has to be changed on the controller side.

Those are great ideas, thanks for sharing. I’ve never seen a B Base controller but I do have some experience with 1092 IC.

Well I made the rechargeable version of the Fluke 289 battery. 5ah is the biggest li-ion battery I could find to fit so it’s about 30% less capacity t...

It looks like earlier Tac50s did use the +/- 12v supply from PS1. Don’t think I’ve ever seen one. It probably doesn’t go anywhere but the rack though....

Tac50s didn’t use the +\- 12v supply. That was a TIII thing, don’t remember on a TIV but PS1 on a Tac50 should just be a 5vdc supply. There is somethi...

Every time I’ve encountered something like this I’ve found some fuse downstream is the wrong size or type. Every circuit coming out of that transforme...

WD LED has to be on for the door board to function. Probably a bad door board but before replacing, check power supplies to it and for these older doo...

2.3K ohms to ground on your harness is not okay. You should have at least a Meg ohm. It’s not he CLC (or at least not just the CLC) if you can’t talk ...

If JP1 2-5 are NOT all off, it’s all plug & play. You can swap the car and hall boards to test, just match the dip switches.

Since the CLC LED comes on the CLC software is running. With a bad power supply you don’t get the watchdog. Can you talk to the selector and door with...

I’d pretty much second that except we did always use at least a 4’ level to “rock” the stacked rails straight before nailing down the fish plate bolts...

Your can replace just the display board but I kind of doubt that’s the problem. You could try swapping just the display board with the car PI to find ...

Make sure the valid opening parameters are correct if your software is new enough. You could have the 56-59 set correctly for the car but not the 52-5...

My guess would be:AAA23500CK13 for the Phase 1 switch AAA23500CK15 for the Phase 2 switch