Elevator Forum

Did you do a backup scan after changing P16? TBS

You can’t modify it like that. You need to buy a UIT from TKE and they’ll send you a new job config that matches the new UIT.

Split the car and hall with in-line fuses smaller than SI-6. Next time you blow you’ll know for sure where the short is. I wouldn’t want to dive into ...

Maxwell, are you an AI?

Here is the original:0k737nqa3psiqv5&st=eahfirao&dl=0

I would suggest scoping the CAN bus. A likely reason for this would be missing suppressors on any of the contactors. If that was the cause it would be...

I don’t know GAL controllers but anything you want to keep noise out of like encoder or comm wiring you do not ground on both ends for any reason. It ...

Hmm… how did I not know that? I guess I haven’t done a door operator upgrade on one.

Just out of curiosity, what controller has a discrete operator that doesn’t leave DO/DC outputs on until the limit?

That’s the 1530 for sure

That’s great, does anyone have a picture or price for this thing

There is now an interface board to put an LD-16 operator on a DMC. There is no way to adapt a discrete operator to a DMC-1 controller

The chip type you’re using isn’t the problem if it works on one Dataman but not another

The blue and tan ones have different chips inside the H21 is W25Q32JV SOIC16

Everything is done through the UI on the CPU. There is a program that requires a special LON interface but Kone won’t sell it to you. If you need to s...