Notifications
Clear all
Topic starter
16/02/2026 9:59 am
I've never seen or used a Kone service tool before, and we recently purchased the service tool laptop from Kone. The only software is Miprom1 and Miprom21 but this job is a KCM831... (Neither of which would connect) What would be the correct application for this controller?
Last edited by RyeGuy; 02/16/26 02:03 AM.
17/02/2026 8:59 am
You don’t use a tool on a KCM831
17/02/2026 9:12 am
You got that right!
Topic starter
17/02/2026 9:16 am
Well I’ll be damned…
What is used to monitor IO and setting up the LON network etc?
17/02/2026 6:24 pm
The CPU is how you see most of that. If you have a the laptop you can use that for programming the cop or you can flash program it manually with the special key switch they have.
18/02/2026 8:59 am
Everything is done through the UI on the CPU. There is a program that requires a special LON interface but Kone won’t sell it to you. If you need to setup a whole COP or several buttons at once you have to buy the programming key switch from Kone then go through a procedure to clear config and reprogram.