Elevator Forum

I had a mech that use to use a 3 or 4" belt sander to get the lining pretty damn close. He put on the brakes, e stop land the cat drop the arms sand t...

The instructions are about useless. If you've already done it don't bother looking at the instructions, they're not very good. I've seen them before a...

You can retain the old door locks and pick up rollers 3 ways. You can just use the movfr with the direct drive mount and add the ramp for the clutch t...

Pm me your email And I'll send you some pictures. It's kinda hard to explain some of the tools

I'd rather repack a 330a twin post with 3 stage pistons then one of those tks.. we built a kit and system for doing the schindler packings and start o...

Just spin the head back on if you have to repick a section and choke it. Also some of that packing kit makes it nice so you know you didn't cut the se...

I have found that a good rule of thumb to get close to the empty car weight is that it is roughly the same as the capacity. Once I was told that Ive c...

Hey not to try an hijack this thread, but I had to go out to a tac32t that I guess was faulting out on a fault that said the car was slipping through ...

Did you replace a cpu40 with cpu561 ?

Godspeed sir

For me this was a while ago and I don't really remember.. and I just looked up the kv1p i referenced above and that did not look like the valve we use...

I'd like to start by saying I only have guesses about an area to think about. Id really have to print everything out and sit down with it for a long t...

Rand h for hall calls

Are these walk in pits? If so bring the car down as low as it will go, kill the power, loosen the glove rope guard, disconnect the gov rope from the c...

You keep ignoring, where are you and what type of plant is it