Elevator Forum

Notifications
Clear all

330A repack

43 Posts
37 Users
0 Reactions
44.2 K Views
(@hope-poke)
Trusted Member
Joined: 17 years ago
Posts: 74

   
ReplyQuote
(@jeff-marmur)
Eminent Member
Joined: 17 years ago
Posts: 18

   
ReplyQuote
(@josh-h)
New Member
Joined: 17 years ago
Posts: 2

   
ReplyQuote
(@jprice)
New Member
Joined: 17 years ago
Posts: 2

   
ReplyQuote
(@jprice)
New Member
Joined: 17 years ago
Posts: 2

   
ReplyQuote
(@bowtiedrooster16)
Reputable Member
Joined: 17 years ago
Posts: 279

   
ReplyQuote
(@bowtiedrooster16)
Reputable Member
Joined: 17 years ago
Posts: 279
 
Their is one specialty tool that definitely makes life easier but not needed. It's a set of cup/plugs that fit in the end of the section that sits in the bottom oil boot/cup and then A rod that holds the piston about 2' up off the oil boot/cup.



   
ReplyQuote
(@beaupeep)
Honorable Member
Joined: 17 years ago
Posts: 316

   
ReplyQuote
(@luar8678)
New Member
Joined: 17 years ago
Posts: 1
 
We tried contacting DL Martin about these instructions and they wouldn't give them to us. Is there any way I could get a copy of the instructions, it would be greatly appreciated, and helpful. [email protected]. thanks



   
ReplyQuote
(@gohana256)
Eminent Member
Joined: 17 years ago
Posts: 29

   
ReplyQuote
(@up-down)
New Member
Joined: 17 years ago
Posts: 1

   
ReplyQuote
(@uhrice)
New Member
Joined: 17 years ago
Posts: 1
 
I just did my first inverted jacks and it wasn’t too difficult. We had the stand and the cups which really came in handy. I would still like a copy of the instructions to compare it with our process. If anyone can share that would be appreciated. [email protected]



   
ReplyQuote
(@bowtiedrooster16)
Reputable Member
Joined: 17 years ago
Posts: 279
 
The instructions are about useless. If you've already done it don't bother looking at the instructions, they're not very good. I've seen them before and the diagrams were all faded and the information is pretty general and basic. If you've already found all the Allen screws and managed to make it through once you've succeeded



   
ReplyQuote
Page 3 / 3
Share:
Scroll to Top